miniBee r3

was designed in Korea commissioned by Samsung Art and Design Institute (SADI). It helps integrating an Arduino Mini or chip with equivalent pin-outs to an XBee radio modem. It also makes all the stamp's pins available for you to solder your sensors.

On the board's back you will have to solder a voltage regulator and a couple of SMT resistors for interfacing the XBee with the Arduino through the serial port. There is also room for a reset button, a LED to indicate there is power in the battery and connectors for the extra analog pins on the standard Arduino Mini boards.

Note: this is just the breakout board, if you want the kit with all the components included check at the DIY kits.